Pleaide | CeraMem | Kleansep supplier page
About Pleaide | CeraMem | Kleansep
Flat sheet polymeric membranes in a plate and frame configuration for use external to the MBR. The membrane on each plate may be isolated from the others. The plates are easily disassembled in order to permit mechanical cleaning if necessary due to a process upset or other reasons.
Ceramic membranes on SiC monolith support structure for use external to the MBR. 144 mm diameter x 864 mm long, with square feed channels having hydraulic diameters of 2 mm and 5 mm.
Tubular ceramic membranes on Al2O3 supports for use external to the MBR. 25 mm and 40 mm diameter, 1178 mm long, with feed channel diameters ranging from 2 mm to 6 mm.
Dimensions for guidance only and may change − please confirm with supplier:
Product pore sizes:
- 1 kDa, 5 kDa, 8 kDa, 15 kDa, 50 kDa, 150 kDa, 300 kDa,
- 10 nm, 50 nm,
- 0.1 µ, 0.2 µ, 0.45 µ, 0.8 µ, 1.0 µ
Membrane area per unit floor area (m2/m2):
- Pleaide: 20.1
- CeraMem: 70−72
- Kleansep: 134
Note: based on a membrane rack including piping header
Membrane module height (m):
- Pleaide: 1.2
- CeraMem: 0.94
- Kleansep: 1.21
Heights given are based on the membrane module
Membrane area per unit volume (m2/m3):
- Pleaide: 45
- CeraMem: 750 for single element module; 308 for MEV
- Kleansep: 877
Please note: the observed flux rates are different for each type, so a direct comparison of membrane areas does not represent a complete comparison.
MBR Case studies and specifications
Last updated: 9 September 2020
Information on this page has been supplied by third parties. You are reminded to contact the third party concerned to confirm information is accurate, up to date and complete before acting upon it.