Biotreatment process configurations in membrane bioreactors

The contaminant removal achieved by any biological process is dependent on whether oxygen is present, and in what form. Aerobic processes require dissolved oxygen to convert organic carbon to carbon dioxide and ammonia to nitrate (nitrification). These both represent biochemical oxidative ‘aerobic’ processes.

In the absence of dissolved oxygen, organic carbon may still be oxidised if an alternative source of oxygen is present from an oxyanion and specifically from nitrate (NO3-). This then presents a means of removing nitrate, a nutrient, from the wastewater.

Nitrate formed from nitrification of ammonia can be converted to nitrogen gas by biochemical reaction with organic carbon, a process known as ‘denitrification’. This can only take place if dissolved oxygen is absent but nitrate is present conditions described as ‘anoxic’.

Returning the treated nitrate-rich sludge to an anoxic zone in front of the aerobic treatment step thus allows the nitrate to be removed, a process modification known as the ‘Modified Ludzack-Ettinger’ (MLE) process. A combination of aerobic nitrification and anoxic denitrification permits most of the ‘total nitrogen’ (TN) to be removed.

Figure 1.  N removal by the Modified Ludzack−Ettinger process | About Mbrs Simon Judd Biotreatment Process Configurations 1
Figure 1. N removal by the Modified Ludzack−Ettinger process

If there is no source of oxygen to allow any biochemical reaction with the organic carbon to take place either from oxygen or oxyanions then the conditions are described as ‘anaerobic’. In the treatment of municipal wastewater, anaerobic conditions are applied as a treatment step in assisting the removal of phosphate from the water. 

Biological phosphorus removal (BPR) in this manner proceeds through recirculation of the sludge to an anaerobic zone. This promotes phosphate removal in two ways:

  1. by encouraging the phosphate to be taken by the biomass (the microbiologically active component of the sludge), and
  2. releasing the biological phosphate as inorganic phosphate, which can then be removed by chemical precipitation.
Figure 2.  Example of biological P removal process | About Mbrs Simon Judd Biotreatment Process Configurations 2
Figure 2. Example of biological P removal process

Acknowledgements

© Text and images copyright Judd & Judd Ltd

Share this page

Disclaimer:

Information on this page has been supplied by third parties. You are reminded to contact the third party concerned to confirm information is accurate, up to date and complete before acting upon it.